内蒙古快3:ANT5158D19B-120DP

内蒙古快3 www.jzcsy.com 5GHz 19dBi Mimo Sector Antennas

Learn more

Installation Requirements


?  13mm wrench

?  Shielded Category 5 (or above) cabling should be used for all wired Ethernet

          connections and should be grounded through the AC ground of the PoE.

          We recommend that you protect your networks from the most brutal environments and 

          devastating ESD attacks with industrial grade shielded Ethernet cable.

ANT5158D19A-DP Quick Start Guide.png



Bracket  Installation



①  Open the waterproof cover,attach the RF Cables to the connectors of antenna

②  Press the bracket handle,align the mounting tabs on the back of the Station with 

      the four mounting slots on the bracket,Slide the Rocket down until it locks into place.

ANT5158D19A-DP -1.png


③  Unscrew the plastic nut on the interface of station

④  Connect the other end of the 2 RF cables to the station and close waterproof cover.


ANT5158D19A-DP -2.png


⑤  Secure the Slotted U-Bracket to the upper Mounting Lugs of the antenna using two nuts.

      Secure the Slotted U-Bracket to the lower Mounting Lugs of the antenna using two nuts.


ANT5158D19A-DP -3.png


⑥  Open the antenna small fixing clip, fix the two small fixing clips to the pole

      with the disc mother, and mount the antenna to the pole.

0.png Note: The mounting assembly can accommodate a ? 30 - 70 mm pole.


ANT5158D19A-DP -4.png



⑦ Completed installation.



ANT5158D19A-DP -5.png


⑧  The antenna has an Mechanical downtilt of 4°. To further adjust the elevation angle:

      a. loosen four bolts on the U bracket and two butterfly nuts on the pole clamp.

      b. Slide the antenna to the desired tilt.

         (The brackets may slide along the pole, depending on the angle of the elevation tilt)

      c. Tighten all bolts and nuts to approximately 25 N-m.



ANT5158D19A-DP -6.png

Technical Specifications

Electrical

Frequency Range

5100-5850MHz

Gain

18dBi ± 1.5dBi

Polarization

Vertical and Horizontal

Isolation

>25dB

F/B Ratio

>25dB

Horizontal Beamwidth(6dB) 

120° type

Vertical Beamwidth(3dB) 

4° type

V.S.W.R

<2

Max Power

20W

Nominal Impedance 

50Ω

Lightingprotection 

DC Ground

Mechanical

Connector 

2 x RPSMA

Antenna Size 

78.5×15×2cm

Antenna Weight 

3kg

Colour

gray

Antenna cover material 

UV Protection ABS

Operatingt emperature

-40°C to +70°C (-32°F to +158°F)


STAY IN TOUCH

? 2020 Lanbowan Technolgy Ltd. All rights reserved.
Terms of Service | 内蒙古快3 | Legal
{ganrao}